How Wide-Bandgap Power Electronics Accelerates the Aging of Insulation
Wide-bandgap (WBG) power semiconductors such as SiC and GaN are revolutionizing modern drives, inverters, and power modules. They enable higher voltages, higher switching frequencies, and more compact designs. However, these advantages come with a downside: insulation materials are subjected to significantly greater stress than with conventional silicon transistors.
This article explains why this is the case, what stress mechanisms occur, and how developers can protect against them.
Why WBG semiconductors place greater demands on insulating materials
WBG transistors have a larger bandgap between the valence band and the conduction band. This allows them to:
• switch higher voltages
• support higher frequencies
• operate at higher temperatures
• achieve higher power densities
However, all of this leads to increased electrical and thermal stress on the insulation in coils, motors, and power electronics.
Traditional tests are no longer sufficient
Insulation materials are traditionally tested under 50 Hz alternating current – often in combination with:
• Thermal stress
• Temperature cycling
• Vibration
• Contact with other insulating materials
However, these test methods no longer realistically reflect the stresses experienced by modern WBG systems.
New Stress Factors Caused by WBG Electronics
1. Higher voltages → Risk of corona and creepage discharges
In real-world components, high voltages almost always encounter phase boundaries between components and air. This promotes:
• corona discharges
• partial discharges
• electrical erosion of the insulation
These occur, for example, in:
• potted coils
• cavities
• connecting wires
• conductor junctions
2. High switching frequencies → Heating due to dielectric losses
WBG transistors generate extremely steep dU/dt edges and short signal durations. This leads to:
• significant heating in the insulating material
• accelerated aging
• reduced breakdown voltage (temperature-dependent)
Particularly critical: harmonic distortions extending into the MHz range, which cause additional losses.
3. DC voltages with AC ripple → electrochemical migration
With DC voltages, another mechanism comes into play:
• Ion migration within or on the surface of the insulating material
• Risk of conductive paths
• Additional aging due to ECM
Thermal Stress: The Most Important Factor in Aging
Internal heating caused by dielectric losses is one of the most significant factors driving aging.
Since temperature determines the service life of most insulating materials, this service life is significantly reduced in WBG electronics.
Real-World Example: Traction Motors in Vehicles
Extreme temperature fluctuations can occur in vehicles:
• Winter: Windings cool down to below –20 °C
• Sudden power demand: Windings heat up abruptly
Consequences:
• The paint insulation can crack
• Partial discharges occur
• Air takes over as insulation → significantly worse
Solution: Additional foil insulation
Wrapping with suitable films – such as Kapton® CRC—provides:
• additional insulation
• high resistance to partial discharges
• significantly greater operational reliability
Stranded Wire Instead of Solid Wire: Advantages at High Frequencies
At high currents or frequencies, the skin effect occurs: the current flows only near the surface → higher resistance.
Stranded wires solve this problem:
• many thin filaments
• large surface area
• lower losses
However, the stranded wires themselves require external insulation, especially in modern inverters.
Plastic Wrap as Insulation
Products such as CMC 70100 (Kapton® adhesive tape) offer:
• excellent insulation despite their thin profile
• stable spiral winding
• high temperature resistance
• high resistance to partial discharges (Kapton® CRC / CMC 70300)
CMC has been supplying these winding films for over 20 years.
Conclusion: WBG electronics require new isolation concepts
The advantages of SiC and GaN power transistors are enormous—but they increase the stress on insulation due to:
• Heat
• High voltages
• High frequencies
• Partial discharges
• Electrochemical migration
Modern applications therefore require more robust insulation materials, optimized winding techniques, and additional protective layers.